Magigoo Original 3D Printer Bed Adhesive – PLA, PETG, ABS, ASA, TPU & HIPS

Reliable first-layer adhesion while hot. Easy release when cool.

Magigoo Original helps prevent first-layer lifting and warping on long prints. Apply a thin layer to the build area before printing; the part grips the heated plate during the print and releases more easily after the plate has cooled.

Using a flexible or polymeric build surface such as PEI? Consider Magigoo Supergrip, which is formulated specifically for flexible and polymeric surfaces.

Compatible materials

• PLA
• ABS and ASA
• PETG
• TPU
• HIPS

Why makers use Magigoo Original

• Strong when hot, easy when cool: helps hold the first layer during printing and release the finished part after cooling.
• Over 100 applications: a thin, even layer is normally enough.
• Water clean-up: wipe the cool build plate with a damp cloth.
• Low-fuss application: no spray, scraper or extra applicator required.
• Works on common surfaces: including glass, PEI, BuildTak, powder-coated flexible plates and Kapton tape.

How to use

1. Shake the bottle for 5–10 seconds.
2. On a clean, cool build plate, press the spring-loaded nib against the surface to start the flow.
3. Spread a thin, even layer over the active print area.
4. Print, allow the bed and part to cool, then remove the part.
5. Clean residue with water and a damp cloth.

Applicator care: do not squeeze the bottle like a ketchup bottle. The valve opens when the nib is pressed against the bed; squeeze only very gently, if needed, while the valve is engaged.

Ready stock in Singapore with local seller support.